Application Procedure Of Fog Machine

- Sep 20, 2017 -

     According to the specifications of the machine assembly, and check the location of the correct parts, screw fastening, belt and pulley operation flexible, elastic, protective cover intact. According to the specifications specified in the specification to the crankcase to add lubricating oil to the specified level, after each use before the inspection, and in accordance with the provisions of the gasoline engine inspection and add lubricating oil.Fog Machine

     Start the engine (how to start see instructions), low-speed operation 10-15 minutes, if there is water spray and no abnormal sound, can be gradually raised to the rated speed, and then the unloading handle press, and the clockwise direction to gradually tighten the pressure wheel pressure, After the pressure is indicated to the required working pressure (usually 2.5-3.5MPa), tighten the nut. Plunger pump Butter cup should be filled with butter at any time, each use two hours should be the butter cup downward rotation of 2 to 3 laps.Fog Machine

     Every day after the completion of the operation should be under pressure, with water to continue spraying 2-5 minutes, cleaning the pump and the pipeline residual liquid, to prevent internal residues of liquid corrosion of the body. Remove water suction strainer and spray hose, open the outlet switch, press the unloading handle, loosen the pressure handwheel, so that the pressure spring is in loose state, rotate the engine or pump with the hand, eliminate the pump memory water, and scrub the unit exterior dirt.Fog Machine

     According to the requirements of the instruction manual, replace the engine and plunger pump crankshaft box oil regularly. If the crankcase is too dirty, use diesel oil to clean the inner cavity and add oil. Prevention and control of the end of the season, the long-term storage equipment, should completely eliminate the pump water, prevent corrosion of the machine and cold weather, and remove the triangle belt, spray gun, hose, mixer, filter, etc., clean and dry, as far as possible suspension preservation. Clean the fuel and oil in the gasoline engine.Fog Machine

     Note that the liquid pump in use should not be dehydrated to prevent damage to the V-shaped aprons and plunger, especially when starting and transferring.Fog Machine


Previous:Introduction To The Working Characteristics Of Bubble Machine Next:The Related Introduction Of Laser Light Positioning Sensor